Magnetostrictive Level Sensors: Float, Interface and Datum
Level sensing uses the same waveguide as position sensing; the difference is the float instead of a magnet ring. This page orders the site’s level articles the way a site engineer meets them: what changes with a float, how to pick one, how to install it, then calibration and upkeep.

01Principle: one part differs
- How a Magnetostrictive Level Sensor Reads Liquid Level: A Float Instead of a Magnet, and a Zero Set by the Mounting Datum
A magnetostrictive level sensor differs from the displacement version by one part: the slider on the probe becomes a float instead of a magnet ring. That single swap changes what is being measured, how the zero is established, and which media properties matter. This article covers the three mounting forms and which tank each suits, why the zero follows the flange sealing face or the way a flexible gauge is straightened and fixed, why density and dielectric constant do not enter the reading, and the cases where a level sensor is the wrong choice.
02Float and interface selection
- Choosing a Level Float: Density, Diameter, Pressure, Material
A wrong float fails in two opposite ways: too light and it rides to the top and stops, too heavy and it sits on the bottom. Four checks decide it, and density is the hard gate.
- Oil-Water Interface: Float Density Between Two Media
Interface sensing differs from level sensing by float density alone: set between the light and heavy media, the float settles at the interface. Three conditions defeat it and should stop you choosing a float type.
03Installation and dead zones
- Level Gauge Installation: Depth, Dead Zone and Bypass Clearance
Sizing a level gauge by tank height is the classic mistake: the upper dead zone lands at full level and the reading freezes. Insertion depth, dead zone position and bypass clearance must be checked together.
04Calibration and upkeep
- Magnetostrictive Level Gauge Calibration: Zero and Span
Level gauge calibration differs from displacement sensor zeroing in one respect: the datum is the liquid surface, not a mechanical face. Three datum options, the full two-point procedure, and three site practices that void the result.
- Level Gauge Guide Tube: Cleaning Intervals and Aging Signs
The guide tube is not maintenance-free. Scale and build-up change coupling between float and waveguide, so level readings drift and the symptom gets attributed to calibration. Cleaning intervals by media, approved methods, and four aging signs.
05Related products
- Series 19 analog magnetostrictive displacement sensorSeries overview
- Series 19 SSI digital interface magnetostrictive displacement sensorSeries overview
- Series 19 CANopen bus magnetostrictive displacement sensorSeries overview
- Series 19 Profibus bus magnetostrictive displacement sensorSeries overview
- Series 19 EtherCAT bus magnetostrictive displacement sensorSeries overview
Frequently Asked Questions
Q: Can a level sensor and a position sensor be swapped?
They share the electronics, waveguide and scaling; only the sliding part differs, a fixed magnet ring for position and a float for level. Swap the ring for a float, move the datum from a mechanical face to the liquid surface, and a position sensor becomes a level sensor.
Q: The level reading is low all the time. Is the sensor faulty?
Check three things first: float density against the medium, scale on the rod, and whether the datum has moved. Level is a relative measurement, so a shifted datum offsets the whole range.
