Germanjet news, technical articles and resources
No output or jumps? The magnetostrictive displacement sensor head splits into pulse drive, echo detection, processing, output. Match block to fault.
The ring magnet is not stronger-is-better. For a magnetostrictive displacement sensor, weak remanence loses the echo; match remanence, gap, mount.
Storage temperature is survival unpowered only. A magnetostrictive displacement sensor is accurate over operating temperature, head narrower than rod.
Several magnets on one rod: a magnetostrictive displacement sensor reads 2-4 positions in echo order, but Series 19 needs 76 mm minimum spacing.
Refresh rate must beat the control cycle of a magnetostrictive displacement sensor. Wave travel grows with range, so long-stroke units refresh slower.
Stuck on CANopen Node-ID and PDO mapping? This fieldbus guide for a magnetostrictive displacement sensor covers Node-ID, PDO not SDO and 120-ohm ends.
Does a magnetostrictive displacement sensor need warm-up? The head self-heats and settles in about 30 min; then steady temperature stops drifting.
Every stroke end hides a dead zone on a magnetostrictive displacement sensor. Never guess 30 mm - take Series 16, 17 and 19F blind-zone figures.
Power cut? An incremental encoder must re-home; a magnetostrictive displacement sensor need not, because torsion-wave timing holds absolute position.
Three accuracy terms on a magnetostrictive displacement sensor: smallest step, scatter to a point and full-stroke deviation are not the same number.
Wild readings come from mounting, not failure. On a magnetostrictive displacement sensor, set magnet coaxiality, two-point zero, screened earthing.
No output, jumps or offset on a magnetostrictive displacement sensor? Check the 20.4-28.8 V supply and polarity, then magnet coaxiality and zero.